LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Engine Cooling System (Diesel)) >> Removal And Installation >> Block Heater >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  2. Disconnect the block heater electrical connector.
  3. Remove the block heater.
    • Remove and discard the O-ring seal.
    • To install, tighten to 41 Nm (30 lb-in).
  4. To install, reverse the removal procedure.
    • Install a new O-ring seal and lubricate it with clean engine coolant.
  5. NOTE: The cooling system condition must be evaluated before filling the cooling system. Failure to follow these instructions can damage the engine or cooling system.

    Evaluate the cooling system condition. For additional information, refer to COOLING SYSTEM CONDITION EVALUATION .

scientia non olet · About LEMON Manuals