Wiper Motor - Windshield

Wiper Motor - Windshield

Removal and Installation

NOTE: A new wiper motor assembly comes with the linkage arm installed.

1. Remove the wiper mounting arm and pivot shaft assembly. For additional information, refer to Wiper Mounting Arm and Pivot Shaft Wiper Mounting Arm and Pivot Shaft.

2. NOTICE: Do not remove the wiper motor linkage arm from the wiper motor assembly. If the arm is removed, the wiper arms may not park in the correct location.

Remove the windshield wiper motor.

1. Using a flat-blade screwdriver or a suitable tool at the location shown, separate the wiper motor linkage arm from the wiper pivot arm linkage.

2. Remove the 3 wiper motor bolts.
- To install, tighten to 18 Nm (159 lb-in).





3. To install, reverse the removal procedure.