Wiper Mounting Arm and Pivot Shaft

Wiper Mounting Arm and Pivot Shaft

Removal and Installation

1. Remove the cowl panel grille. For additional information, refer to Front End Body Panels Service and Repair.

2. Remove the 3 wiper mounting arm and wiper pivot shaft bolts.
- To install, tighten to 18 Nm (159 lb-in).





3. Disconnect the electrical connector and detach the wire harness pin-type retainer.

4. Remove the wiper mounting arm and wiper pivot shaft.

5. To install, reverse the removal procedure.
- Adjust the wiper pivot arms. For additional information, refer to Wiper Blade and Pivot Arm Adjustment - Windshield Adjustments.