LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Explorer Base, AWD, 6F50 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center, And Warning Chimes >> Diagnostic Routine(S) >> Diagnostic Routine DD >> Pinpoint Test

Pinpoint Test

  1. RETRIEVE THE RECORDED Diagnostic Trouble Codes (DTCs) FROM THE Instrument Panel Cluster (IPC) SELF-TEST
    1. Using a scan tool, perform the Instrument Panel Cluster (IPC) self-test.
    • Are any Diagnostic Trouble Codes (DTCs) recorded? 
    1. Yes:  REFER to DTC CHART: INSTRUMENT PANEL CLUSTER (IPC) .
    2. No:  GO to 2  on page 2.
  2. RETRIEVE THE RECORDED Diagnostic Trouble Codes (DTCs) FROM THE Powertrain Control Module (PCM) SELF-TEST
    1. Using a scan tool, perform the Powertrain Control Module (PCM) self-test.
    • Are any Four-Wheel Drive (4WD) Diagnostic Trouble Codes (DTCs) recorded? 
    1. Yes:  REFER to DTC CHART: POWERTRAIN CONTROL MODULE (PCM) .

      For all other Diagnostic Trouble Codes (DTCs), REFER to the appropriate Powertrain Control/Emissions Diagnosis (PC/ED) manual INTRODUCTION - GASOLINE MODELS .

    2. No:  GO to 3  on page 2.
  3. CHECK THE DISPLAY MODE MENU
  1. On the optional Instrument Panel Cluster (IPC), in the display mode menu, press the Left Hand (LH) steering wheel switch to the right to display the Four-Wheel Drive (4WD) gauge.
  2. On the base Instrument Panel Cluster (IPC), in the Information display mode, press the Left Hand (LH) steering wheel switch to the right then down to display the Four-Wheel Drive (4WD) gauge.
  1. Yes:  The Four-Wheel Drive (4WD) gauge is operating correctly at this time. The display mode was not set to correct display mode.
  2. No:  INSTALL a new Instrument Panel Cluster (IPC). REFER to INSTRUMENT PANEL CLUSTER (IPC) .
scientia non olet · About LEMON Manuals