LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Focus S, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrument Cluster (Ic), Message Center, & Warning Chimes >> General Procedures >> Belt-Minder® Deactivating/Activating >> Deactivating/Activating

Belt-Minder® Deactivating/Activating: Deactivating/Activating

  1. Turn the ignition switch to the RUN position (do not start the engine).
  2. Wait approximately 1 minute until the safety belt warning indicator turns off.
    3. NOTE: Step 3 must be completed within 50 seconds after the safety belt warning indicator turns off.
    NOTE: Buckle and unbuckle the safety belt at a moderate rate. If the safety belt buckled/unbuckle/buckle sequence is carried out too fast, the restraints control module (RCM) may fail to recognize one of the sequences and the procedure must be repeated.
  3. To disable the seating position, buckle then unbuckle the safety belt 9 times, ending in the unbuckled state.
    • After Step 3, the safety belt warning indicator illuminates for 3 seconds then turns off.
  4. Within 10 seconds of the indicator turning off, buckle then unbuckle the safety belt.
    • This disables the Belt-Minder® feature for that seating position, if it is currently enabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds.
    • This enables the Belt-Minder® feature for that seating position, if it is currently disabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds, followed by 3 seconds with the light off, then followed by the safety belt warning indicator flashing 4 times per second for 3 seconds again.
scientia non olet · About LEMON Manuals