Speaker Walk-Around Test - Base AM/FM Audio Unit
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The audio unit must be turned on to enter the speaker walk-around test.
- To enter the test, press and hold preset buttons 3 and 6 simultaneously for approximately 3 seconds, then release.
- The test applies sound to each speaker for 1-2 seconds. Speakers are tested in the following sequence: RH, LH.
- To exit the test, turn the key to OFF or turn the audio unit off.
- If the concern remains and the fault is not detected, go to Symptom Chart .