LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Engine - 3.0L (2V)) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the crankshaft front seal.
    • Lubricate the seal lip with clean engine oil.
    • Using the special tool, install the crankshaft front seal.
      Fig 1: Installing Crankshaft Front Seal Using Special Tool (303-175)
      GF0009119Courtesy of FORD MOTOR CO.
  2. Install the crankshaft damper. For additional information, refer to Lower End Components - Exploded View  and Crankshaft Pulley  in this article.
scientia non olet · About LEMON Manuals