LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2016 (Windows And Glass - Glass, Frames And Mechanisms) >> Diagnosis And Testing >> Glass, Frames and Mechanisms >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Door window regulator and motor
    • Door glass run
    • Door window glass
    • Loose, corroded connectors
    • Circuitry
    • Window control switch
    • Battery Junction Box (BJB) fuse 39 (40A)
    • Smart Junction Box (SJB) fuses:
      • 1 (30A)
      • 4 (30A)
      • 17 (20A)
      • 41 (15A)
      • 45 (5A)
    • SJB  circuit breaker 47 (30A)
    • Accessory delay relay
    • Rear window defrost relay
    • Rear window defrost grid
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    4. NOTE: Make sure to use the latest scan tool software release.
  4. If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).
    5. NOTE: The Vehicle Communication Module (VCM) LED prove out confirms power and ground from the DLC  are provided to the VCM  .
  5. If the scan tool does not communicate with the VCM  :
    • check the VCM  connection to the vehicle.
    • check the scan tool connection to the VCM  .
    • refer to MODULE COMMUNICATIONS NETWORK , No Power To The Scan Tool, to diagnose no power to the scan tool.
  6. If the scan tool does not communicate with the vehicle:
    • verify the ignition key is in the ON position.
    • verify the scan tool operation with a known good vehicle.
    • refer to MODULE COMMUNICATIONS NETWORK to diagnose no response from the SJB  .
  7. Carry out the network test.
    • If the scan tool responds with no communication for one or more modules, refer to MODULE COMMUNICATIONS NETWORK .
    • If the network test passes, retrieve and record Continuous Memory Diagnostic Trouble Codes (CMDTCs).
  8. Clear the CMDTCs  and carry out the self-test diagnostics for the SJB  .
  9. If the DTCs retrieved are related to the concern, go to the SMART JUNCTION BOX (SJB) DTC CHART . For all other DTCs, refer to MULTIFUNCTION ELECTRONIC MODULES .
  10. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .
scientia non olet · About LEMON Manuals