LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1983 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Removal And Installation >> Message Center Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

MKX 

    NOTE: The transmission selector lever bezel is held in place by 4 tabs that are located in the shifter assembly.
  1. Remove the transmission selector lever bezel.
  2. Open the floor console compartment door and pull the floor console finish panel straight up to release the retainer clips and remove the finish panel.
  3. Remove the 2 pin-type retainers and the storage compartment assembly.

    All vehicles 

  4. Pull the instrument panel center finish panel straight out to release the retainer clips and remove the instrument panel center finish panel.
    • Disconnect the electrical connectors.
  5. Press the 4 retaining tabs and remove the message center switch.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals