Instrument Cluster (IC): Removal

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: When installing a new Instrument Cluster (IC), it is necessary to upload the module configuration to the scan tool. For additional information, refer to MODULE CONFIGURATION .

NOTE: If installing a new IC , all vehicle keys are erased during the parameter reset procedure. Verify at least 2 of the vehicle keys are available prior to carrying out this procedure.

Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Remove the 2 screws and the lower steering column cover.
- If equipped, disconnect the ambient air temperature sensor air hose and electrical connector.
Tilt the steering column to the lowest position.
Edge

NOTE: The instrument panel center finish panel is held in place by spring clips located on the finish panel.

Pull the instrument panel center finish panel straight out to release the retaining tabs and position aside.
All vehicles
Release the 4 locating tabs on the IC finish panel gap reveal from the upper steering column cover.

Fig 1: Locating Tab On IC Finish Panel Gap
Courtesy of FORD MOTOR CO.

NOTE: The upper section of the IC finish panel is held in place by spring clips located on the finish panel.

Remove the 2 screws and the IC finish panel.
- If equipped, disconnect the power liftgate switch electrical connector.
Remove the 4 screws and the IC .
- Disconnect the electrical connector.