Instrument Cluster (IC): Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

Position the IC , connect the electrical connector and install the 4 screws.

NOTE: The upper section of the IC finish panel is held in place by spring clips located on the finish panel.

Position the IC finish panel, connect the power liftgate switch electrical connector (if equipped) and install the 2 screws.
Install the 4 locating tabs on the IC finish panel reveal into the upper steering column cover.
Edge
Position and install the instrument panel center finish panel.
All vehicles
Position the lower steering column cover, connect the ambient air temperature sensor hose and electrical connector (if equipped) and install the 2 screws.
Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .

NOTE: If a new IC is installed, download the configuration from the scan tool into the new IC . For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .

NOTE: If a new IC is installed, the IC and the PCM require a parameter reset to allow the IC and the PCM to recognize each other. Failure to carry out the parameter reset to the IC and the PCM may result in a no start condition.

NOTE: The vehicle's integrated keys (or standard Passive Anti-Theft System (PATS) keys) must be programmed to the new IC .

Carry out the parameter reset and key programming procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
Clear all IC and PCM DTCs.