LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1983 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Removal And Installation >> Instrument Cluster (IC) Lens >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Instrument Cluster (IC). For additional information, refer to INSTRUMENT CLUSTER (IC) .
    2. NOTE: Edge shown, MKX similar.
    Fig 1: Locating Instrument Cluster Tabs
    G06503565Courtesy of FORD MOTOR CO.
  2. Release the 8 tabs and remove the lens.
    3. NOTE: Be sure that all the tabs are correctly located to avoid damage to the new lens and fully locked in place to reduce the potential for noise.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals