Pinpoint Test AJ: The Power Liftgate Off Message Is Inoperative
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- AJ1 CHECK THE POWER LIFTGATE OPERATION
- Operate the power liftgate and check for correct operation when the feature is selected on and off. Refer to the Owner's Literature for additional information on selecting the parking aid system on or off.
- Does the power liftgate operate correctly when the feature is selected on then off?
- Yes: GO to AJ2 .
- No: REFER to BODY CLOSURES .
- AJ2 CHECK THE MESSAGE CENTER ON/OFF DISPLAY
- Press the SETUP button until POWER LIFTGATE ON OFF is displayed.
- Does the ON or OFF have the □ > brackets around it indicating the desired selection?
- Yes: If the brackets remain, the system is operating normally at this time. The problem may have been caused by a momentary loss of communication with the LTM .
- No:
PRESS the RESET button to allow the IC
to query the LTM
again.
If the display is still incorrect, REFER to MODULE COMMUNICATIONS NETWORK to diagnose no communication with the LTM .