Camber Adjustment - Front
WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Front camber is adjusted through the use of the upper strut plate. Rotating the upper strut plate 180 degrees will change the camber +0.5 degrees.
- Using alignment equipment and the manufacturer's instructions, measure the camber.
- Remove and discard the stabilizer bar link lower nut and disconnect the link from the lower arm.
- To install, tighten the new nut to 90 Nm (66 lb-ft).
- Remove and discard the 4 strut upper mounting plate nuts.
- To install, tighten the new nuts to 30 Nm (22 lb-ft).
- Using a suitable jack, raise the vehicle body enough to allow the front strut upper plate mounting studs to clear the frame.
- Rotate the upper mounting plate 180 degrees.
- Recheck the front camber settings.
- Check and, if necessary, adjust the front toe. For additional information, refer to TOE ADJUSTMENT - FRONT .
NOTE:
Rotating the upper strut plate 180 degrees will change the camber +0.5 degrees.