Low One-Way Clutch

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not clean in water or with water-based solvents. Damage to the component may occur.

NOTE: The low One-Way Clutch (OWC) cannot be disassembled.

Clean and inspect the low One-Way Clutch (OWC) for cracks and damaged splines. The internal splined section should rotate counterclockwise and lock when rotated clockwise. If any damage is found or the clutch does not rotate or lock, install a new low OWC.

Fig 1: Identifying One-Way Clutch (OWC)

Courtesy of FORD MOTOR CO.

Inspect the forward clutch surface for damage. If the surface is burned or worn excessively, install a new OWC.

Fig 2: Identifying Forward Clutch Surface

Courtesy of FORD MOTOR CO.