Differential Gear Assembly: Disassembly

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: All-Wheel Drive (AWD) shown, Front Wheel Drive (FWD) similar.

Inspect the differential bearings for damage or excessive wear. Install new bearings if necessary.

Fig 1: Identifying Differential Bearings

Courtesy of FORD MOTOR CO.

All-Wheel Drive (AWD) vehicles

Using Step Plate 205-D019, Bearing Puller 205-D064 and Front Wheel Hub Remover/Installer 204-069, remove the right differential carrier bearing from the differential assembly.

Fig 2: Removing Right Differential Carrier Bearing From The Differential Assembly (AWD)

Courtesy of FORD MOTOR CO.

Front Wheel Drive (FWD) vehicles

Using Step Plate 205-D015, Bearing Puller 205-D064 and Front Wheel Hub Remover/Installer 204-069, remove the right differential carrier bearing from the differential assembly.

Fig 3: Removing Right Differential Carrier Bearing From The Differential Assembly (FWD)

Courtesy of FORD MOTOR CO.

All vehicles

NOTE: AWD shown, FWD similar.

Using Step Plate 205-D015, Bearing Puller 205-D064 and Front Wheel Hub Remover/Installer 204-069, remove the left differential carrier bearing from the differential assembly.

Fig 4: Removing Left Differential Carrier Bearing From The Differential Assembly

Courtesy of FORD MOTOR CO.

Inspect the differential assembly and the ring gear for damage and install new if necessary.