Bumper - Front, Lower

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front bumper cover. For additional information, refer to Bumper Cover - Front .
Remove the 2 nuts from the power steering cooler pipe-to-lower front bumper.
- To install, tighten to 7 N.m (62 lb-in).

Fig 1: Locating Nuts From Power Steering Cooler Pipe-To-Lower Front Bumper

Courtesy of FORD MOTOR CO.

Remove the 6 bumper-to-radiator support nuts (3 each side) and remove the lower front bumper.
- To install, tighten to 25 N.m (18 lb-ft).

Fig 2: Identifying Bumper-To-Radiator Support Nuts & Lower Front Bumper

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.