Bumper Cover - Front

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
Remove the 2 bolts from the top of the radiator grille.

Fig 1: Locating Bolts From Top Of Radiator Grill

GF0031129

Courtesy of FORD MOTOR CO.

Remove the 4 scrivets from the top of the radiator grille.

Fig 2: Locating Scrivets From Top Of Radiator Grille

GF0031130

Courtesy of FORD MOTOR CO.

Remove the 3 lower pin-type retainers.

Fig 3: Identifying Lower Pin-Type Retainer

GF0031131

Courtesy of FORD MOTOR CO.

Remove the 6 fender splash shield screws (3 each side).

Fig 4: Identifying Fender Splash Shield Screws

GF0031132

Courtesy of FORD MOTOR CO.

Remove the 4 lower screws (2 each side).

Fig 5: Identifying Lower Screws

GF0031133

Courtesy of FORD MOTOR CO.

Disconnect the side marker lamp electrical connectors, if equipped.

Fig 6: Identifying Side Marker Lamp Electrical Connectors

GF0031134

Courtesy of FORD MOTOR CO.

Disconnect the fog lamp electrical connectors, if equipped.

Fig 7: Identifying Fog Lamp Electrical Connectors

GF0031135

Courtesy of FORD MOTOR CO.

Remove the front bumper cover.
- Pull the corner of the bumper cover from the bracket.

Fig 8: Identifying Front Bumper Cover

GF0031136

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.