LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake System >> Removal And Installation >> Rear Disc Brake >> Installation

Rear Disc Brake: Installation

  1. Clean any rust or foreign material from brake disc and wheel hub.
    • Use specified brake parts cleaner to clean the brake disc and hub mating surfaces.
  2. Apply a thin coat of specified anti-seize lubricant to the hub flange.
  3. Install the brake disc.
  4. Install a new brake disc screw.
    • Tighten to 20 Nm (177 lb-in).
  5. Position the brake caliper and brake caliper anchor plate assembly and install 2 new bolts.
    • Tighten to 103 Nm (76 lb-ft).
    • Apply brakes several times to verify correct brake operation.
  6. Install the wheel and tire. For additional information, refer to WHEELS & TIRES .
scientia non olet · About LEMON Manuals