LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Shift Concern: No 1-2 Shift

Shift Concern: No 1-2 Shift

WARNING: This page is about a different variant/trim than selected.
SHIFT CONCERN: NO 1-2 SHIFT

Possible Component Reference/Action
220 - ELECTRICAL ROUTINE 
Powertrain Control System   
  • PCM, vehicle wiring harnesses, VSS, TR sensor, TSS sensor and SSD.
320 - HYDRAULIC/MECHANICAL ROUTINE 
Fluid   
  • Incorrect level.
Incorrect Pressures   
  • High/low pressures.
Main Control   
  • Bolts not tightened to specification.
  • Tighten to specifications.
  • Separator plate damaged.
  • Inspect for damage. If damaged, repair as necessary.
  • Contamination.
  • Disassemble and clean.
  • Valves/springs damaged, misassembled, missing, stuck, or bore damaged.
  • If damaged or parts are missing, install a new main control assembly. If misassembled, reassemble correctly. DO NOT stone, file or sand valves. This will remove the anodized finish and may result in further main control or transaxle damage.
Servo   
  • Seals (piston and cover) damaged.
  • Inspect for damage. Repair as necessary.
Band   
  • Band damaged.
  • Inspect for damage. Repair as necessary.
  • Servo worn or damaged.
  • Inspect for damage. Repair as necessary.
  • Not adjusted correctly.
  • Adjust correctly
  • Anchor bolt damaged or worn.
  • Inspect for damage. Repair as necessary.
OD Planetary Assembly   
  • Planetary damaged.
  • Inspect for damage. If damaged, repair as necessary.
Forward Clutch Assembly   
  • Seals, piston damaged.
  • Inspect for damage. Repair as necessary.
  • Check balance dam.
  • Inspect for damage. Repair as necessary.
  • Friction elements damaged or worn.
  • Inspect for damage. Repair as necessary.
  • Return springs damaged.
  • Inspect for damage. Repair as necessary.