Shift Concern: Harsh 3-2 Shift

WARNING: This page is about a different variant/trim than selected.

SHIFT CONCERN: HARSH 3-2 SHIFT

Possible Component	Reference/Action
236 - ELECTRICAL ROUTINE
Powertrain Control System
PCM, vehicle wiring harnesses, TSS sensor, TR sensor, TFT sensor and SSE.	Carry out on-board diagnostic tests. Refer to the INTRODUCTION - GASOLINE for diagnosis and testing of the PCM. GO to PINPOINT TEST A , GO to PINPOINT TEST B , GO to PINPOINT TEST C and GO to PINPOINT TEST E . Repair as required. Clear the DTCs, road test and rerun on-board diagnostic test.
336 - HYDRAULIC/MECHANICAL ROUTINE
Incorrect Pressures
High/low pressures.	Check pressure at line tap. Carry out Line Pressure Test. Refer to SPECIAL TESTING PROCEDURES in this article.
Bolts not tightened to specification.	Tighten to specifications.
Separator plate damaged.	Inspect for damage. If damaged, repair as necessary.
Contamination.	Disassemble and clean.
Valves/springs damaged, misassembled, missing, stuck, or bore damaged.	If damaged or parts are missing, install a new main control assembly. If misassembled, reassemble correctly. DO NOT stone, file or sand valves. This will remove the anodized finish and may result in further main control or transaxle damage.
Servo
Seals (piston and cover) damaged.	Inspect for damage. Repair as necessary.
Band
Band damaged.	Inspect for damage. Repair as necessary.
Servo worn or damaged.	Inspect for damage. Repair as necessary.
Not adjusted correctly.	Adjust correctly
Anchor bolt damaged or worn.	Inspect for damage. Repair as necessary.
Direct Clutch Assembly
Seals, piston damaged.	Inspect for damage. Repair as necessary.
Check balance dam.	Inspect for damage. Repair as necessary.
Friction elements damaged or worn.	Inspect for damage. Repair as necessary.
Return springs damaged.	Inspect for damage. Repair as necessary.