LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1178 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the Rear Main Seal Installer onto the end of the crankshaft and slide a new crankshaft rear seal onto the tool.
    NOTE: Lubricate the seal lips and bore with clean engine oil prior to installation.
    Fig 1: Identifying Rear Main Seal Installer
    G06062695Courtesy of FORD MOTOR CO.
  2. Using the Rear Main Seal Installer and Handle, install the new crankshaft rear seal.
    Fig 2: Installing Crankshaft Rear Seal Using Rear Main Seal Installer
    G06252541Courtesy of FORD MOTOR CO.
  3. Install the crankshaft sensor ring.
  4. Install the flexplate. For additional information, refer to Removal and Installation .
  5. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
scientia non olet · About LEMON Manuals