LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1178 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Flexplate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the transaxle. For additional information, refer to TRANSAXLE .
  3. Remove the bolts and the flexplate.
    • To install, tighten to 80 Nm (59 lb-ft).
    NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.
  4. To install, reverse the removal procedure.
  5. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
scientia non olet · About LEMON Manuals