LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls - Powertrain DTC Charts & Description (Except Diesel & Hybrid)) >> Diagnostic Trouble Code (DTC) Charts And Descriptions >> DTC P1244: Generator Load Input High

DTC P1244: Generator Load Input High

WARNING: This page is about a different variant/trim than selected.
P1244 - GENERATOR LOAD INPUT HIGH

Description:  The powertrain control module (PCM) monitors generator load from the generator/regulator in the form of frequency. The fault indicates the input is lower than the load should be in normal operation. The load input could be high when a battery short to ground exists.
Possible Causes: 
  • GENLI circuit short to B+
  • GENRC circuit short to B+
  • B+ open prior to start-up
  • Open GENRC prior to start-up
  • Open ILC prior to start-up
  • Damaged PCM
Diagnostic Aids:  Verify the battery voltage is 14.5 volts.
Verify the generator/regulator has the correct part number.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to HY: Generator/Regulator System STEP HY1.
scientia non olet · About LEMON Manuals