DTC P0723: Output Shaft Speed (OSS) Sensor Circuit Intermittent

WARNING: This page is about a different variant/trim than selected.

P0723 - OUTPUT SHAFT SPEED (OSS) SENSOR CIRCUIT INTERMITTENT

Description:	The OSS sensor signal to the PCM is irregular or interrupted.
Possible Causes:	Harness connector not properly seated Harness intermittently shorted or open Harness connector damaged OSS sensor damaged, or not installed properly
Diagnostic Aids:	Verify harness and connector integrity. Verify proper installation of the OSS sensor.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
Manual transmission	-	-	GO to TJ: Output Shaft Speed (OSS) Sensor STEP TJ1.
All others	Refer to AUTOMATIC TRANSMISSION .