DTC P0722: Output Shaft Speed (OSS) Sensor Circuit No Signal
WARNING: This page is about a different variant/trim than selected.
P0722 - OUTPUT SHAFT SPEED (OSS) SENSOR CIRCUIT NO SIGNAL
| Description: | The OSS sensor failed to provide a signal to the PCM upon initial movement of vehicle. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Check the wiring, connector, and sensor for damage. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| Manual transmission | - | - | GO to TJ: Output Shaft Speed (OSS) Sensor STEP TJ1. |
| All others | Refer to AUTOMATIC TRANSMISSION . | ||