DTC P0704: Clutch Pedal Position (CPP) Switch Malfunction
WARNING: This page is about a different variant/trim than selected.
P0704 - CLUTCH PEDAL POSITION (CPP) SWITCH MALFUNCTION
| Description: | When the clutch pedal is applied the voltage goes to low. If the powertrain control module (PCM) does not see this change from high to low the DTC is set. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | When the clutch pedal is applied and then released, the CPP switch voltage should cycle. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to TA: Clutch Pedal Position (CPP) Switch STEP TA1. | - | GO to TA: Clutch Pedal Position (CPP) Switch STEP TA1. |