DTC P0620: Generator Control Circuit Failure
WARNING: This page is about a different variant/trim than selected.
P0620 - GENERATOR CONTROL CIRCUIT FAILURE
| Description: | The powertrain control module (PCM) reads the GENLI and sends a DTC through the network when the GENLI indicates a fault. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Verify the battery voltage is 14.5 volts. Verify the generator/regulator has the correct part number. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to HY: Generator/Regulator System STEP HY1. | ||