DTC P2803: Transmission Range Sensor Circuit High Input
WARNING: This page is about a different variant/trim than selected.
P2803 - TRANSMISSION RANGE SENSOR CIRCUIT HIGH INPUT
| Description: | The PCM checks the gear selector position by monitoring 3 independent voltage signals from the transmission range (TR) sensor. The TR voltages are then compared to an allowed voltage range for each gear. The test fails when the compared voltages are out of range. This DTC indicates that 1 TR signal is high. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | See the diagnostic aids for DTC P2800 . | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test TA . | ||