LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine - 2.3L - (Except Hybrid)) >> In-Vehicle Repair >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE: Remove the through-bolt from the special tool.
    NOTE: Lubricate the oil seal with clean engine oil.
    Fig 1: Installing Crankshaft Front Oil Seal Using Special Tool
    G03897717Courtesy of FORD MOTOR CO.
  1. Using the special tool, install the crankshaft front oil seal.
  2. Install the crankshaft pulley. For additional information, refer to LOWER END COMPONENTS - EXPLODED VIEW  and CRANKSHAFT PULLEY .
scientia non olet · About LEMON Manuals