Removal and Installation

CAUTION: Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.

NOTE: Prior to removal of the module, it is necessary to upload module configuration information to the diagnostic tool, this information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .

Depower the supplemental restraint system (SRS). For additional information, refer to AIR BAG RESTRAINT SYSTEMS .
Remove the audio unit. For additional information, refer to AUDIO UNIT .
Remove the headlamp switch knob.
1. Remove the headlamp switch knob.
2. Rotate the headlamp switch bezel counterclockwise and remove.
Fig 1: Removing Headlamp Switch Knob
Courtesy of FORD MOTOR CO.
Remove the instrument panel finish panel.
1. Remove the bolts.
2. Remove the instrument panel finish panel.
  - Disconnect the electrical connectors.
Fig 2: Removing Bolts
Courtesy of FORD MOTOR CO.
Remove the instrument cluster.
1. Remove the bolts.
  - Remove the transmission range indicator and disconnect the electrical connectors.
2. Remove the instrument cluster.
Fig 3: Removing Instrument Cluster
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.