Removal and Installation

Remove the instrument panel cluster finish panel. Refer to INSTRUMENT PANEL AND CONSOLE .
Lower the steering wheel tilt adjustment.
Remove the four instrument cluster screws and pull the instrument cluster away from the instrument panel.
Disconnect the electrical connectors.

Fig 1: Removing Four Instrument Cluster Screws
Courtesy of FORD MOTOR CO.
If equipped, disconnect the transmission range indicator.
- Push in the two clips and pull out the transmission range indicator. Position the indicator aside and remove the instrument cluster.
  
  Fig 2: Pulling Out Transmission Range Indicator
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.