LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2585 (Automatic Transmission - 6R140 (TORQSHIFT(R)6)) -- F250-F550 Super Duty) >> Removal And Installation >> Transmission Control Module (TCM) >> Removal

Transmission Control Module (TCM): Removal

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Transmission Control Module (TCM) is located on the left frame rail under the cab.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
    NOTE: Keep the Transmission Control Module (TCM) electrical connector straight when disconnecting it or damage the connector terminals can occur.
  2. Slide the lock tab out to unlock the Transmission Control Module (TCM) electrical connector and disconnect the TCM  electrical connector.
    Fig 1: Locating TCM Electrical Connector
    G07482890Courtesy of FORD MOTOR CO.
  3. Remove and discard the 2 nuts and remove the TCM  .
    Fig 2: Locating TCM Nuts
    G07482891Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals