LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2585 (Automatic Transmission - 6R140 (TORQSHIFT(R)6)) -- F250-F550 Super Duty) >> Removal And Installation >> Shift Solenoids (SS) >> Removal

Shift Solenoids (SS): Removal

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission fluid pan. For additional information, refer to TRANSMISSION FLUID PAN .
  2. Disconnect the solenoid electrical connector(s) for the solenoid(s) being serviced.
    Fig 1: Locating Solenoid Electrical Connectors
    G07482822Courtesy of FORD MOTOR CO.
  3. Remove the 7 bolts and remove the solenoid retainer.
    Fig 2: Locating Solenoid Retainer Bolts
    G07482823Courtesy of FORD MOTOR CO.
    4. NOTE: Solenoids are calibrated from the factory and are not all the same. To replace a solenoid, match the replacement solenoid type (normally high/normally low) and the band number with the original solenoid or harsh/erratic shifts, harsh/soft engagement or damage to the transmission can occur.
    Fig 3: Locating Main Control Solenoid Ports And Solenoids
    G07482824Courtesy of FORD MOTOR CO.
  4. If replacing more then 1 solenoid, number the solenoids and number the main control solenoid ports to correspond to the solenoid. Pull the solenoid(s) out of the main control valve body.
  5. Remove the solenoid(s) from the solenoid body.
scientia non olet · About LEMON Manuals