LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2585 (Automatic Transmission - 6R140 (TORQSHIFT(R)6)) -- F250-F550 Super Duty) >> Removal And Installation >> Output Shaft Seal - Slip Yoke >> Removal

Output Shaft Seal - Slip Yoke: Removal

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driveshaft. For additional information, refer to DRIVESHAFT .
  2. Using the Torque Converter Fluid Seal Remover and the Slide Hammer, remove the output shaft seal.
    Fig 1: Removing Output Shaft Seal Using Special Tools
    G07482955Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals