LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2585 (Automatic Transmission - 6R140 (TORQSHIFT(R)6)) -- F250-F550 Super Duty) >> Removal And Installation >> Main Control >> Removal

Main Control: Removal

WARNING: This page is about a different car, the 2011 Ford Pickup, 2011 Ford F550 Super Duty, 2011 Ford F450 Super Duty, and 2011 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fluid pan, gasket and filter. For additional information, refer to FLUID PAN, GASKET AND FILTER .
  2. Disconnect the 7 solenoid electrical connectors and the Transmission Fluid Temperature (TFT) sensor electrical connector and position the transmission wiring harness aside.
    Fig 1: Locating Solenoid And Transmission Fluid Temperature (TFT) Sensor Electrical Connectors
    G07482807Courtesy of FORD MOTOR CO.
    3. NOTE: Do not bend the manual valve rod clip when removing the manual valve rod. If the manual valve rod clip is bent back to remove the manual valve rod instead of sliding it off, the manual valve rod clip will become permanently distorted causing total loss of transmission control or transmission failure. If the manual valve rod clip is bent, install a new manual valve rod clip.
    Fig 2: Identifying Manual Valve Rod
    G07482808Courtesy of FORD MOTOR CO.
  3. Remove the manual valve rod. Pull the manual valve rod clip tab out of the TR  sensor, slide the manual valve rod clip off of the manual valve rod and remove the manual valve rod from the TR  sensor and the manual valve.
    1. Manual valve rod clip
    2. Manual valve rod clip tab
    3. TR  sensor
    4. Manual valve rod
    4. NOTE: Slip yoke transmissions have 3 feed tubes and fixed flange/Four-Wheel Drive (4WD) transmissions have 2 feed tubes.
    Fig 3: Locating Main Control And Feed Tube Bolts
    G07482809Courtesy of FORD MOTOR CO.
  4. Remove the 3 main control bolts, 3 feed tube bolts and remove the main control and feed tube assemblies.
    5. NOTE: Note the ports where the feed seals are removed from. Failure to install the feed seals in the ports they were removed from can result in pressure loss and transmission failure.
    Fig 4: Locating Clutch Feed Seals
    G07482810Courtesy of FORD MOTOR CO.
  5. Remove the 4 clutch feed seals.
  6. Remove the 4 pump feed seals.
    Fig 5: Locating Pump Feed Seals
    G07482811Courtesy of FORD MOTOR CO.
    7. NOTE: Slip yoke transmission feed tubes shown in the illustration, fixed flange/ 4WD  transmission feed tubes similar.
    Fig 6: Locating Transmission Feed Tubes
    G07482812Courtesy of FORD MOTOR CO.
  7. Remove the feed tubes.
  8. Remove and discard the O-rings from the feed tubes.
    Fig 7: Identifying O-Rings Of Feed Tubes
    G07482813Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals