LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2060 (Manual Transmission And Clutch - General Information - F250-F550 Super Duty) >> Diagnostic Tests >> Manual Transmission and Clutch >> Component Tests >> Clutch Chatter or Shudder

Clutch Chatter or Shudder

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING AND LIFTING article.
  2. Inspect the engine and transmission mounts for looseness and damage.
    • If the mounts are OK, proceed to the next step in this procedure.
    • If the mounts are loose or damaged, tighten or install new mounts as necessary. Test the system for normal operation.
  3. Check for loose bolts that retain the clutch pressure plate to the flywheel.
    • If the bolts are tightened to specification, proceed to the next step in this procedure.
    • If the bolts are loose, tighten the bolts to specification. Refer to CLUTCH article. Test the system for normal operation.
  4. Remove the clutch disc and pressure plate. Refer to CLUTCH article. Inspect the clutch disc and pressure plate for wear and damage, and check the clutch disc runout. Refer to Clutch Disc Check . Inspect the flywheel for glazing and damage. Check the flywheel runout. Refer to Flywheel Runout Check . Inspect the input shaft for wear, damage and eccentricity. Repair all components as necessary.
scientia non olet · About LEMON Manuals