LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Focus SVT >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Analog Instrument Panels >> Self-Diagnostic System >> Instrument Cluster Test Mode

Instrument Cluster Test Mode

  1. Simultaneously depress and hold TRIPMETER RESET BUTTON and turn ignition switch to RUN position.
  2. Release TRIPMETER RESET BUTTON when TEST is displayed on LCD. This takes between 5 and 8 seconds (instrument cluster will enter gauge sweep test).
  3. Depress TRIPMETER RESET BUTTON to move through following tests. See INSTRUMENT CLUSTER TEST MODE  table. To exit instrument cluster test mode, turn ignition to OFF position.
    INSTRUMENT CLUSTER TEST MODE

    Test Instrument Cluster Display Item Being Tested Description
    Gauge Sweep GAGE Tachometer, Speedometer, Temperature & Fuel Gauges All Gauges Carry-Out Sweep
    Fill In All LCD 8888 LCD Illuminates All Instrument Cluster LCD Indicators
    Indicator Bulbs BULB Indicators Illuminates All Instrument Cluster Controlled Indicators
    ROM Level rXXX Instrument Cluster Read Only Memory Displays Instrument Cluster ROM Revision Level
    NVM Level EXXX Instrument Cluster Non-Volatile Memory Displays Instrument Cluster NVM Revision Level
    DTC XXXX or NONE Diagnostic Trouble Codes (1) To List DTCs Stored, Press RESET button.
    Road Speed MPH XXX.X Speedometer Displays Speed Signal Input In MPH
    Road Speed Km/h XXX.X Speedometer Displays Speed Signal Input In Km/h
    Speedometer Gauge Driver XXX.o Speedometer Displays the hexadecimal value (000-400 decimal 1-1024) for the speedometer gauge driver counts
    Engine Speed XXXX Tachometer Displays Tachometer Input In RPM
    Tachometer Gauge Driver XXX.t Tachometer Displays the hexadecimal value (000-400 decimal 1-1024) for the tachometer gauge driver counts
    Fuel Volume FXXX Fuel Sender System Displays Fuel Volume Signal Input
    SCP Percent Fuel Level LXXX Fuel Sender System Displays The Transmitted SCP Message Data In Percent Fuel Level (000-255
    Fuel Gauge Driver XXX.F Fuel Gauge Displays The Hexadecimal Value (000-13F decimal 000-319) For The Fuel Gauge Driver Counts
    Engine Coolant Temperature XXXC Engine Coolant Temperature Displays Engine Coolant Temperature Input
    Engine Coolant Temperature Gauge Driver XXX.C Engine Coolant Temperature Gauge Displays The Hexadecimal Value (000-13F decimal 000-319) For The Temperature Gauge Driver Counts
    Battery Voltage bXXX Battery Voltage Displays Battery Voltage Input
    ABS Fail Ab-[H/L] ABS Displays ABS Raw Instrument Cluster Input (H = Overcharging Or Battery; L = Ground)
    Electronic Brake Distribution (EBD) failure Eb-[H/L] EBD System Displays EBD Raw Instrument Cluster Input (H= Overcharging Or Battery; L = Ground)
    Illumination IL-[H/L] Instrument Cluster Illumination Displays Instrument Cluster Illumination (H = ON; L= OFF)
    Crank Sense Cr-[H/L] Instrument Cluster Crank Sense Displays Instrument Cluster Crank Sense (H = Ignition, L = Ground Or Overcharging
    Port A-D A-HH, b-HH, C-HH and d-HH Instrument Cluster Displays Instrument Cluster Port Values (Used When Requesting Assistance From Ford Hotline
    A/d input 0 0XXX Instrument Cluster Displays Instrument Cluster A/d Input Value In Decimal Value (Battery Reference Input)
    A/d input 1 1XXX Instrument Cluster Displays Instrument Cluster A/d Input Value In Decimal Value (All Gauge Driver Status, Lo = Not Okay, Hi = Okay)
    A/d input 2 And 4-7 2XXX and 4XXX-7XXX Instrument Cluster Displays Instrument Cluster A/d Input Value In Decimal Value (All Gauge Driver Status, Lo = Not Okay, Hi = Okay)
    A/d input 3 3XXX Instrument Cluster Displays Instrument Cluster A/d Input Value In Decimal Value (Trip/Reset Button, Lo = Pressed, Hi = Not Pressed)
    Personality Byte #1-Byte #4 P1XX-P4XX Instrument Cluster Displays Instrument Cluster Personality Configuration For Byte #1-#4
    (1) See DIAGNOSTIC TROUBLE CODE INDEX  table.