LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 3.8L V6 (VIN 4) >> Removal & Installation >> Crankshaft Rear Oil Seal >> Installation

Crankshaft Rear Oil Seal: Installation

  1. Lubricate seal and mating surfaces with engine oil. Install seal on crankshaft with spring side toward crankshaft. Using Seal Installer (T95P-6701-EH), install seal so rear face of seal is within .005" (.13 mm) of rear surface of cylinder block.
    2. CAUTION: Apply thread sealant on threads of drive plate or flywheel bolts before installing.
  2. To install remaining components, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals