LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 3.8L V6 (VIN 4) >> Removal & Installation >> Crankshaft Front Oil Seal >> Installation

Crankshaft Front Oil Seal: Installation

  1. Lubricate seal and sealing surfaces with engine oil. Install seal using Seal Installer (T88T-6701-A and T70P-6B070-A).
  2. Coat seal surface of vibration damper with engine oil. If key is removed from crankshaft, apply small amount of silicone sealant to keyway in crankshaft, and install key.
  3. Using Vibration Damper Installer (T82L-6316-A), install vibration damper. To install remaining components, reverse removal procedure.
  4. Tighten bolts to specification. See TORQUE SPECIFICATIONS . Ensure reference marks align on crankshaft pulley and vibration damper.
scientia non olet · About LEMON Manuals