LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 3.8L V6 (VIN 4) >> Removal & Installation >> Camshaft >> Installation

Removal & Installation: Camshaft: Installation

  1. To install, ensure oil holes in camshaft bearings and cylinder block align. Apply sealant to rear camshaft bore plug before installing.
    NOTE: Oversize rear camshaft bore plug can be identified by oversize stamped on flat area of plug. Ensure proper size plug is installed.
  2. Lubricate camshaft lobes and bearing surfaces with Assembly Lubricant (D9AZ-19579-C). Install camshaft. Tighten thrust plate bolts to specification. See TORQUE SPECIFICATIONS .
    3. CAUTION: When filling cooling system, bleed air from system by removing vent plug from elbow on intake manifold behind thermostat housing. DO NOT rotate plastic cap under vent plug, or gasket may be damaged. Fill cooling system until coolant flows from vent plug. Install and tighten vent plug to 11 ft. lbs. (15 N.m).
  3. Ensure camshaft end play is within specification. See CAMSHAFT  table under ENGINE SPECIFICATIONS. To complete installation, reverse removal procedure. Refill cooling system.
scientia non olet · About LEMON Manuals