Retrieving Codes
WARNING: This page is about a different variant/trim than selected.
Fault codes are retrieved from EEC-V system through 16-pin Data Link Connector (DLC). DLC is located below instrument panel, to right of steering column. Self-diagnostic test procedures are for use with New Generation Star (NGS) tester. If an aftermarket scan tool is used, ensure tool is OBD-II certified and refer to scan tool manufacturer's operating procedures.
During QUICK TEST, 3 types of DTCs are retrieved: KOEO, KOER and continuous memory codes. See QUICK TEST under DIAGNOSIS & TESTING for self-test procedures. DTCs may be cleared from PCM memory after they have been recorded or repaired. See CLEARING DIAGNOSTIC TROUBLE CODES under DIAGNOSIS & TESTING.