LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Focus ZX3, Standard >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panels - Analog >> Self-Diagnostic System >> Instrument Cluster Test Mode

Instrument Cluster Test Mode

  1. Simultaneously depress and hold TRIPMETER RESET BUTTON and turn ignition switch to RUN position.
  2. Release TRIPMETER RESET BUTTON when TEST is displayed on LCD. This takes between 5 and 8 seconds (instrument cluster will enter gauge sweep test).
  3. Depress TRIPMETER RESET BUTTON to move through following tests. See INSTRUMENT CLUSTER TEST MODE  table. To exit instrument cluster test mode, turn ignition to OFF position.
    INSTRUMENT CLUSTER TEST MODE

    Test Instrument Cluster Display Item Being Tested Description
    Gauge Sweep GAGE Tachometer, Speedometer, Temperature & Fuel Gauges All Gauges Carry-Out Sweep
    Fill In All LCD 8888 LCD Illuminates All Instrument Cluster Controlled Indicators
    Indicator Bulbs BULB Indicators Illuminates All Instrument Cluster Controlled Indicators
    ROM Level rXXX Instrument Cluster Read Only Memory Displays Instrument Cluster ROM Revision Level
    NVM Level EXXX Instrument Cluster Non-Volatile Memory Displays Instrument Cluster NVM Revision Level
    DTC XXXX or NONE Diagnostic Trouble Codes To List DTCs Stored, Press RESET button. See DIAGNOSTIC TROUBLE CODE INDEX  table.
    Road Speed MPH XXX.X Speedometer Displays Speed Signal Input In MPH
    Road Speed Km/h XXX.X Speedometer Displays Speed Signal Input In Km/h
    Engine Speed XXXX Tachometer Displays Tachometer Input In RPM
    Fuel Volume FXXX Fuel Sender System Displays Fuel Volume Signal Input
    Engine Coolant Temperature XXXC Engine Coolant Temperature Displays Engine Coolant Temperature Input
    Battery Voltage bXXX Battery Voltage Displays Battery Voltage Input
    ABS Fail Ab-[H/L] ABS Displays ABS Raw Instrument Cluster Input (H = Overcharging Or Battery; L = Ground)
    Electronic Brake Distribution (EBD) failure Eb-[H/L] EBD System Displays EBD Raw Instrument Cluster Input (H= Overcharging Or Battery; L = Ground)
    Illumination IL-[H/L] Instrument Cluster Illumination Displays Instrument Cluster Illumination (H = ON; L= OFF)
    Crank Sense Cr-[H/L] Instrument Cluster Crank Sense Displays Instrument Cluster Crank Sense (H = Ignition, L = Ground Or Overcharging
scientia non olet · About LEMON Manuals