LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Focus LX, Standard >> Repair and Diagnosis >> Transmission >> Automatic Transmission Diagnosis >> Diagnosis & Testing >> Transaxle Drive Cycle Test

Transaxle Drive Cycle Test

NOTE: The transmission drive cycle test must be followed exactly.
NOTE: When performing transaxle drive cycle test, refer to VALVE BODY SOLENOID OPERATION  table under DESCRIPTION & OPERATION for correct solenoid operation.
  1. After repairing any engine performance DTCs, erase remaining transaxle DTCs. Warm engine to normal operating temperature. Ensure transaxle fluid level is correct. Place gearshift lever in "D" position with Overdrive on.
  2. Moderately accelerate vehicle from stop to 50 MPH. Hold speed for at least 15 seconds. Lightly apply and release brakes. Hold speed and throttle steady for an additional 5 seconds. Bring vehicle to a stop and remain stopped for a minimum of 20 seconds.
  3. Repeat step  2 at least 5 times. Retrieve and record DTCs. Perform appropriate diagnostic procedure. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under READING DIAGNOSTIC TROUBLE CODES.
scientia non olet · About LEMON Manuals