LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Diagnosis - 4R100 >> Diagnosis & Testing >> Reading Diagnostic Trouble Codes >> Continuous Memory Codes (Intermittent Faults)

Continuous Memory Codes (Intermittent Faults)

CAUTION: Continuous memory codes should be recorded when retrieved. These codes may be used to identify intermittent problems that exist after all KOEO and KOER codes have been repaired. Some continuous memory code faults may not be valid after KOEO and KOER codes are serviced.

These codes result from information stored by PCM during continuous self-test monitoring. Use these codes for diagnosis only when KOEO SELF-TEST and KOER SELF-TEST result in SYSTEM PASS and all steps in QUICK TEST  are successfully completed. These codes indicate faults previously recorded. Fault may or may not be currently present. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table.

After noting and/or repairing fault, clear DTCs from memory. See CLEARING DIAGNOSTIC TROUBLE CODES . Intermittent faults may be caused by a sensor, connector or wiring-related problem.

DIAGNOSTIC TROUBLE CODE IDENTIFICATION

DTC (1)

Code Description

 System Test
P0237  MAP Sensor Out Of Range  Rerun QUICK TEST .
P0705  Digital TR Sensor Not In Park Or Neutral  D 
P0708  Digital TR Sensor Circuit Voltage High  D 
P0712  TFT Sensor Indicates 315°F (157°C), Sensor Circuit Grounded  B 
P0713  TFT Sensor Indicates -40°F (-40°C), Sensor Circuit Open  B 
P0715  Insufficient Input From TSS Sensor  F 
P0717  Intermittent TSS Sensor Signal  F 
P0718  Noisy TSS Sensor Signal  F 
P0720  Insufficient Input From OSS Sensor  F 
P0721  Noisy OSS Sensor Signal  F 
P0722  Intermittent OSS Sensor Signal  F 
P0731  Fault code can be set by other non-electronic-related transmission hardware condition. See 1-2 Shift Error, SS1, SS2 Or Internal Components  . A 
P0732  Fault code can be set by other non-electronic-related transmission hardware condition. See 2-3 Shift Error, SS1, SS2 Or Internal Components  . A 
P0733  Fault code can be set by other non-electronic-related transmission hardware condition. See 3-4 Shift Error, SS1, SS2 Or Internal Components  . A 
P0741  TCC Slippage Detected  See appropriate test in SYMPTOM DIAGNOSIS  under TROUBLE SHOOTING.
P0743  Output circuit check, generated ONLY by electrical conditions. See TCC Solenoid Circuit Failure  . C 
P0750  Output circuit check, generated ONLY by electrical conditions. See SS1 Solenoid Circuit Failure   A 
P0755  Output circuit check, generated ONLY by electrical conditions. See SS2 Solenoid Circuit Failure  . A 
P0781  Fault code can be set by other non-electronic-related transmission hardware condition. See 1-2 Shift Error  . A 
P0782  Fault code can be set by other non-electronic-related transmission hardware condition. See 2-3 Shift Error  . A 
P0783  Fault code can be set by other non-electronic-related transmission hardware condition. See 3-4 Shift Error  . A 
P1000  Incomplete OBD-II Testing  N/A 
P1111  System Pass Code  N/A 
P1124  TP Sensor Out Of On-Board Diagnostics Range  Rerun to QUICK TEST  at appropriate TP sensor position per engine application. See ON-VEHICLE ADJUSTMENTS - TRUCKS article in ENGINE PERFORMANCE.
P1702  Digital TR Sensor Signal Intermittent  D 
P1703  BPP Switch Malfunction  Rerun QUICK TEST  and activate switch.
P1704  Digital TR Sensor Failure In Transition State  D 
P1705  TR Sensor Not In Park Or Neutral  D 
P1711  TFT Sensor Out Of On-Board Diagnostics Range  Warm vehicle to normal operating temperature and rerun QUICK TEST .
P1713  No Change In TFT Sensor-Low Range  B 
P1714  SS1 Mechanical Failure  H 
P1715  SS2 Mechanical Failure  H 
P1718  No Change In TFT Sensor-High Range  B 
P1728  Transmission Slippage  See appropriate test in SYMPTOM DIAGNOSIS  under TROUBLE SHOOTING.
P1729  4WD Low Circuit Failure  TG 
P1740  TCC Mechanical Failure  H 
P1744  Transmission Slippage  See appropriate test in SYMPTOM DIAGNOSIS  under TROUBLE SHOOTING.
P1746  Output circuit check, generated ONLY by electrical conditions. See EPC Solenoid Control Driver Failure  . E 
P1747  Output circuit check, generated ONLY by electrical conditions. See EPC Solenoid Circuit Shorted Or PCM  . E 
P1754  CCS Circuit Open Or Shorted, Or PCM Driver Failure  G 
P1760  EPC Solenoid Signal Intermittent Short  F 
P1780  Rerun QUICK TEST  and activate switch. See TCS Not Changing State  . TB 
P1781  4WD Low Circuit Failure  TG 
P1783  Transmission Temperature Exceeded 270°F (132°C)  B 
(1) Only engine performance-related DTCs that may affect transmission operation are listed. For complete list of engine performance-related DTCs, see appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
scientia non olet · About LEMON Manuals