Test N: Left Turn Indicator Inoperative
- Turn ignition switch to LOCK position. Disconnect instrument cluster connector C224. Place multifunction switch in LEFT turn position. Turn ignition switch to RUN position. Measure voltage between ground and terminal No. 16 (Light Green/White wire) at instrument cluster connector C224. See Figure. If battery voltage exists, replace instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. If battery voltage is not present, go to next step.
- Disconnect multifunction switch connector C250. Measure resistance of Light Green/White wire between terminal No. 8 at multifunction switch connector C250 and terminal No. 16 at instrument cluster connector C224. See Figure and Fig 1 . If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open in Light Green/White wire between multifunction switch and instrument cluster.
- Turn ignition switch to LOCK position. Check for continuity across left turn indicator bulb. If continuity does not exist, replace bulb. Retest system. If continuity exists, replace instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Retest system.