LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Engine Controls - System & Component Testing) >> Evaporative Emission System Tests >> Evaporative Emissions System Leak Test

Evaporative Emissions System Leak Test

WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: EVAP emission canister must not be pressurized to more than one psi (6.8 kPa) or damage to EVAP emission canister may occur.
NOTE: EVAP test port is located near cowl top vent panel.

Connect Evaporative Emissions System Leak Tester (134-00056) to EVAP test port. Close canister vent solenoid. See CANISTER VENT CONTROL SOLENOID CLOSING PROCEDURE . Follow manufacturer's instructions included with evaporative emissions system leak tester and test evaporative system for leakage.

scientia non olet · About LEMON Manuals