Pinpoint Test AR: Random Misfire Detected: Introduction: Detection/Management

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2004 Ford RV Cutaway, 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, and 2004 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

The misfire detection monitor will be enabled only when certain engine conditions are satisfied. If the PCM is unable to detect which cylinder is misfiring or multiple cylinders are misfiring the PCM will set a random misfire DTC.

CAUTION: The PCM harness connectors must be properly seated and the connector latch properly attached to eliminate possible driveability concerns or a no start condition. Installing the PCM connectors on an angle may cause an improper connection, misdiagnosis and damaged components. Install the connector until the lever pivots and seats itself. Apply light pressure to get the connector into position on the PCM and then fully seat the connector.

NOTE: Visually inspect the harness connectors for corrosion, damage, proper mating and correct pin tension.

NOTE: When the PCM is disconnected additional DTCs will be set. Clear all DTCs after restoring the vehicle.