LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 747 (Engine Controls - Pinpoint Tests - 6.0L Diesel (99P E-Series & 99P F450/550)) >> General Procedures for Pinpoint Testing >> Harness Resistance Tests

Harness Resistance Tests

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2004 Ford RV Cutaway, 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, and 2004 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

Harness resistance tests are carried out when a circuit is suspected of having high resistance or being open. These tests are carried out with the ignition off. Measure resistance from the sensor connector end to the processor connector. If an open circuit or high resistance is encountered, the problem is most easily isolated by separating the circuit at the interim connectors and measuring resistance through both halves of the circuit.

scientia non olet · About LEMON Manuals