Instrument Cluster Diagnostic Trouble Code (DTC) Index

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

DTC DESCRIPTION ACTION

DTC	Description	Source	Action
B1201	Fuel Sender Circuit Failure	Instrument Cluster	Go To PINPOINT TEST B: INCORRECT FUEL GAUGE INDICATION .
B1204	Fuel Sender Circuit Short to Ground	Instrument Cluster	Go To PINPOINT TEST B: INCORRECT FUEL GAUGE INDICATION .
B1205	Reset Button Circuit Failure	Instrument Cluster	VERIFY that the instrument cluster bezel is aligned correctly and the Select/Reset button is not binding. REPAIR as necessary. If the switch is not binding, INSTALL a new instrument cluster. Refer to INSTRUMENT CLUSTER .
B1317	Battery Voltage High	Instrument Cluster	INSPECT the charging system. Refer to CHARGING SYSTEM - GENERAL INFORMATION .
B1318	Battery Voltage Low	Instrument Cluster	Go To PINPOINT TEST A: NO COMMUNICATION WITH THE INSTRUMENT CLUSTER .
B1342	ECU Is Defective	Instrument Cluster	NOTE: If other DTCs are present, REPAIR them before installing a new component. CLEAR the DTCs. RETRIEVE the DTCs. If DTC B1342 is retrieved again, INSTALL a new module. Refer to INSTRUMENT CLUSTER . REPEAT the self-test.
B1345	Heated Backlite Input Circuit Short to Ground	Instrument Cluster	Refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION .
B1352	Ignition Key-In Circuit Failure	Instrument Cluster	Refer to WARNING DEVICES .
B1360	Ignition Run/Acc Circuit Open	Instrument Cluster	Go To PINPOINT TEST A: NO COMMUNICATION WITH THE INSTRUMENT CLUSTER .
B1607	Illuminated Entry Input Circuit Failure	Instrument Cluster	Refer to INTERIOR LIGHTING .
B2143	Non-Volatile Memory Failure	Instrument Cluster	INSTALL a new instrument cluster. Refer to INSTRUMENT CLUSTER . REPEAT the self-test.
B2477	Module Configuration Failure	Instrument Cluster	Attempt to re-configure the instrument cluster again. If B2477 is retrieved again, INSTALL a new instrument cluster. Refer to INSTRUMENT CLUSTER . REPEAT the self-test.
B2658	Wait to Start Warning Indicator Circuit Open	Instrument Cluster	CARRY-OUT the instrument cluster self-test. If the wait to start indicator proves out normally, REFER to the appropriate INTRODUCTION article to continue diagnosis. Otherwise, INSTALL a new instrument cluster. Refer to INSTRUMENT CLUSTER .
C1284	Oil Pressure Switch Failure	Instrument Cluster	Go To PINPOINT TEST D: INCORRECT OIL PRESSURE GAUGE INDICATION .
P1139	Water in Fuel Indicator Circuit	Instrument	CARRY-OUT the instrument cluster self-test. If
Open		Cluster	The water in fuel indicator proves out normally, REFER to the appropriate INTRODUCTON article to continue diagnosis. Otherwise, INSTALL a new instrument cluster. Refer to INSTRUMENT CLUSTER .
U1027	Invalid/Missing Data for Engine RPM	Instrument Cluster	To Pinpoint Test F.
U1041	Invalid/Missing Data for Vehicle Speed	Instrument Cluster	Go To PINPOINT TEST H: THE SPEEDOMETER/ODOMETER IS INOPERATIVE/THE SPEEDOMETER IS INACCURATE .
U1058	Invalid/Missing Data for Transmission/Transaxle/PRNDL	Instrument Cluster	Refer to TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS .
U1059	Invalid/Missing Data for Transmission/Transaxle/PRNDL	Instrument Cluster	Refer to TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS .
U1073	Invalid/Missing Data for Engine Coolant	Instrument Cluster	To Pinpoint Test E.
U1123	Invalid/Missing Data for Odometer	Instrument Cluster	Go To PINPOINT TEST H: THE SPEEDOMETER/ODOMETER IS INOPERATIVE/THE SPEEDOMETER IS INACCURATE .
U1262	SCP Communication Bus Fault	Instrument Cluster	Refer to MODULE COMMUNICATIONS NETWORK to continue diagnostics.

ABS MODULE DIAGNOSTIC TROUBLE CODE (DTC) INDEX

ABS MODULE DIAGNOSTIC TROUBLE CODE

DTC	Description	Source	Action
C1220	ABS Lamp Output Circuit Short to Battery	ABS Module	Go To PINPOINT TEST L: THE ABS WARNING INDICATOR IS INOPERATIVE .